The common foundation for all

Logic subsystems to control and monitor signals.

SeqCross enables sequences to run parallel.​

Choose from ready-made function blocks.

This segment provides functionalities that are usable by the PLC program.

CMZ are zones that are constantly monitored independently of the sequences. This allows safety-critical zones to be monitored and automatic operation to be switched off in the event of a fault.

Continuously monitored hardware zone. In case of a malfunction, the automatic operation is suspended.

The standard includes two operating modes and are generated without programming effort.

Each bit is defined and monitored at any time. Every deviation is detected and diagnosed bit by bit.

The PLC program controls the modeled process. You only define the valid states as a sequence. All your states are digitally verifiable at any given moment. ​

The PLC program monitors every move of the machine. In case of deviations, an error is reported, and the automatic operation is suspended.

An additional analyzing tool to monitor power switches, cutout switches, etc. In case of a failure, the machine stops immediately.

MXIC are manual cross interlocks that enable certain movements to be blocked in manual mode. A critical movement can be blocked if two movements correlate with each other. This process increases the operational safety as well as the operability of the system during operation.

The PLC program monitors every move of the machine. In case of deviations, an error is reported, and the automatic operation is suspended.

Is the interface to the human which is used to control and diagnose the plant. It is automatically generated based on the process model and linked with the PLC software.