Drag and Drop your required functionalities​.

The model is organized into different layers for easier understanding.

Ready-made function blocks assist you with defining your model—import and export your functions.

Based on the model, a PLC program is generated containing all functionalities, HMI and operating modes.​

The process model is defined independently from the target system.

The logic layer enables the user to plan the process without knowledge—easy-to-use process mapping with sequence definition and graphical overview.

Keep notes relating to details of the plant or the commissioning progress - All in one place.

Only once your machine is up and running and all requirements are met, you pay per use with Selmo Tags.

Indication of the minimum, maximum, and average time of all states.

Enables the user to follow the plant’s steps and states in real-time.

Logic subsystems to control and monitor signals.

SeqCross enables sequences to run parallel.​

Choose from ready-made function blocks.

This segment provides functionalities that are usable by the PLC program.

CMZ are zones that are constantly monitored independently of the sequences. This allows safety-critical zones to be monitored and automatic operation to be switched off in the event of a fault.

Continuously monitored hardware zone. In case of a malfunction, the automatic operation is suspended.

The standard includes two operating modes and are generated without programming effort.

Each bit is defined and monitored at any time. Every deviation is detected and diagnosed bit by bit.

The PLC program controls the modeled process. You only define the valid states as a sequence. All your states are digitally verifiable at any given moment. ​

The PLC program monitors every move of the machine. In case of deviations, an error is reported, and the automatic operation is suspended.

An additional analyzing tool to monitor power switches, cutout switches, etc. In case of a failure, the machine stops immediately.

MXIC are manual cross interlocks that enable certain movements to be blocked in manual mode. A critical movement can be blocked if two movements correlate with each other. This process increases the operational safety as well as the operability of the system during operation.

The PLC program monitors every move of the machine. In case of deviations, an error is reported, and the automatic operation is suspended.

Is the interface to the human which is used to control and diagnose the plant. It is automatically generated based on the process model and linked with the PLC software.